Venning Travers Crane, used for handling of casting plates with tiles or concrete stones in drying chamber, but can also, be used for other purposes and adapted to the customer's needs.

The travers crane is constructed of two powerful steel profiles, supported by a lattice construction.

Throughout the length of the main frame, a pliers hang, which, in addition to the gripping function, can be raised and lowered, via a scissor-controlled knee joint.

The function is done via a wire pull, with weighing cells to four points on the pliers. The wire pull is powered by an SEW gear.

The arms of the pliers are activated using an SEW gear via center tubes and connecting rods.

The crane runs on 4-wheel blocks with belt pulls on both sides.

The belt pull is powered by an SEW gear.

The travers crane can lift a wide range of plates with products and transport them horizontally in the building and stack them for accumulation as well as for further transport.

Control Siemens PLC. S 7 1500 and Electrical power supply with sliding system.